Rightline Gear 100A21 Quick Start Manual

threading its end through its loop, and pulling tight (Fig 5).

3-Thread the straps up through slot A and down through

slot B of the buckles (Fig 6) and tighten the straps evenly.

4-Tie off the strap ends so they don't flap in the wind (Fig

7). Make sure to re-tighten the straps after a few miles

and check them regularly throughout the trip.

NOTE: IF A STRAP MAKES NOISE WHILE DRIVING,

LOOSEN THE STRAP, RE-POSITION IT SLIGHTLY,

AND RE-TIGHTEN IT.

Attach The Carrier - WITHOUT A Roof Rack

1-Purchase the Rightline Gear Replacement Car Clips

2-Run a strap's loop through the backside of a Car Clip

3-Thread the strap's end through its loop (Fig 10).

4-Pull the strap's end to tighten the strap around the Car

Clip (Fig 11).

Related Manuals for Rightline Gear 100A21

Edge car top carrier (2 pages)

Ace car top carriers (2 pages)

Ace car top carriers (2 pages)

Trunk storage bag for jeep wrangler (8 pages)

Car clip strap set (2 pages)

Car top carriers (2 pages)

Range car top carriers (2 pages)

Sport car top carriers (2 pages)

Car back carrier (2 pages)

For jeep wrangler '07-'16 2-door jk (5 pages)

Truck tent (2 pages)

Suv tailgating canopy (2 pages)

Summary of Contents for Rightline Gear 100A21

• Page 1 Video: Side Rail The correct attachment of this product is critical and Cross beyond the control of Rightline Gear. The safe use Cross and long life of this product depends entirely on your good judgment and following these directions. Side.
• Page 2 Loop 8-Open the vehicle’s doors and hook the Car Clips under Car Clip the door frame weather molding (Fig 15). Fig 9 Fig 8 Loop Strap End Fig 15 Fig 10 Fig 11 9-Tighten the straps evenly (Fig 16 and Fig 17) and shut 5-Repeat steps 1-3 for the other (3) straps.